Synchronous belt damage forms Synchronous with common problems and solutions
Synchronous belt damage forms
1, the tension is not enough:
If the tension is not enough, so the friction will be not enough, so that the skid happens, let wear increase of synchronous belt, transmit other lost the ability to load, transmission instability to take losing efficacy.
2, the tension is too big:
Synchronous belt on the tension is too large, deformation is serious, the lifespan of the synchronous belt to reduce.
3, synchronous take leave stuff:
If there synchronization with grease and other dirt, because dirt contains the chemical material, it can enter the synchronous belt, destroying its material structure.
4, synchronous belt wheel not to is:
If the synchronous belt wheel is not appear to align the cause of synchronous belt skid, distortion and internal fever and wear, so must be for synchronous belt wheel.
5, the length of the synchronous belt is not equal to:
If a row is not equal to the length of the belt, each the size of the synchronous belt on the tension will be different, some can produce skid or tension is too big, make a wear to synchronous belt. Therefore, must choose when using the same type of synchronous belt.
6. And if a synchronous belt for a long time didn't work, we have to make it open, otherwise it will reduce the lifespan of the synchronous belt, synchronous belt deformation occurred.
7. And if a synchronous belt placed too long, it will appear to rubber aging and reduce life.
8, if use the scene environment there is dust, acid and alkali waste gas or other damage of the synchronous belt, it will also make a shortened lifespan of the synchronous belt.
9, vibration amplitude is too big:
If the machine vibration and the synchronous belt fast twitch, this will let the synchronous belt is basked in by severe situation, so as to reduce the use fixed number of year.
10., start the overload:
Synchronous belt in overload under the conditions of operation, will produce too much tension, led to the synchronous belt damaged due to sliding.
11, synchronous pulley groove worn:
Synchronous belt wheel used for too long, groove edge wear and tear, Angle is not correct, synchronous belt will touch the bottom of the trough, to drive the machine, and have to increase the tension, the triangle have been broken.
The common problems in synchronous belt
1, the synchronous belt tooth broken
2, with abnormal wear and tear
3, synchronous belt use tooth edge serious wear and tear
4, synchronous belt running deviation
5, synchronous belt longitudinal open
Synchronous belt solution
1, do not kink belt, wide belt or big pulley installation, increase the pulley diameter or width of the belt, removal of foreign bodies, right up tight.
2, correct tension, installation width greater, higher power transmission belt/increase the size of the synchronous belt and pulley size, check the belt type, if necessary, replace
3, replace the synchronous belt wheel.
4, re-align axis, replace belt wheel flange, reinforcement bearing or chassis.
5, re-align axis, replace belt wheel flange, reinforcement bearing or chassis.
6, replace the flange pulley, re-align pulley/shaft, correct tension, removal and installation of protective cover, check the cutting device and guide.
- Pre：Port of tape industry for the 2016/9/1
- Next：Gangda enhanced industrial syn 2016/8/30
